Bounty Hunter LONEGWP Manuel du propriétaire télécharger pdf (Page 8)

89

ALL METAL MODE:

There are two ways to enter the

ALL-METAL mode.

1)

Press the Disc/All Metal touch pad.

or

2) Turn the detector on. (The detector

always defaults to the All Metal

mode when first powered on).

DISCRIMINATION MODE:

To enter DISCRIMINATION mode,

1) Press the Disc touch pad, and

2) Turn the Disc/Notch control knob

clockwise.

In the DISCRIMINATION mode, the

detector will emit three distinct

tones, depending on the type of

metal detected.

As you turn the Disc Knob

clockwise, you will progressively

“discriminate out,” or eliminate from

detection, different types of metals.

Refer to the illustration below as a

reference for the levels required to

discriminate out different objects.

The DISCRIMINATION mode is a

fixed-start-point system. As you turn

the knob to the right, more objects are

progressively eliminated, including the

items to the left. Use

DISCRIMINATION for coin-shooting

and detecting in trashy areas.

If you encounter certain bothersome

trash items, program their rejection

into your detector as follows:

1) Turn the Disc/Notch knob 100%

counterclockwise.

2) Pass the undesirable object under

the search coil.

3) Turn the Disc/Notch knob slowly

clockwise until the object is no

longer detected.

AUTO NOTCH MODE

To enter the AUTO NOTCH mode,

press the Auto Notch touch pad. In

AUTO NOTCH mode, iron, most pull

tabs, and screw caps are automatically

eliminated.

In addition, you can turn the Disc/Notch

control to selectively eliminate more items

beyond the pre-programmed ones.

You can eliminate unwanted items in the

middle of the magnetic spectrum, but

still retain more valuable nickels.

AUTONOTCH is useful to “notch out”

specific unwanted items.

MODES OF OPERATION

ALL METAL TOUCHPAD

DISC TOUCHPAD

AUTO NOTCH TOUCHPAD

The principle use for the SENSITIVITY

knob is to eliminate

ELECTROMAGNETIC INTERFERENCE

(EMI). EMI is both naturally-occurring

and man-made. Common sources of

EMI are power lines, both suspended

and buried, and broadcasting

antennas. Machinery, when in

operation, can also produce EMI.

EMI comes from most household

appliances, so

YOUR DETECTOR

CAN BEHAVE VERY ERRATICALLY

INDOORS. If you want to test it

indoors, turn off the TV and

microwave. If you have lights with

dimmer switches, also turn these off;

dimmer switches can produce lots of

EMI.

If your detector chatters with the

SENSITIVITY knob in the 100%

clockwise position, reduce the

sensitivity until the chatter stops

(usually to the 1:00 or 3:00 position).

If you suspect the presence of deeper

targets underneath a shallower target,

reduce the SENSITIVITY to eliminate

the detection of the deeper target to

properly locate and identify the

shallower target.

LOW BATTERY INDICATOR:

The LOW BATT indicator will flash as

the unit is powered on. If the

indicator comes on and stays on,

replace the batteries.

SENSITIVITY ADJUSTMENT

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire