Bounty Hunter Tracker II Manuel d'utilisateur télécharger pdf (Page 3)

EASY ASSEMBLY

Assembly of this unit is easy and requires no special tools.

The only assembly required is to attach the search coil and

lower stem to the upper stem and on to the control housing.

Fresh batteries can then be installed and the detector will be

ready for use.

1. Depress the adjustment button on the lower stem.

2. Push the lower stem into the upper stem.

3. Wind the search coil cable around the stem.

CAUTION: Provide enough slack in the cable near the search

coil to allow for angle adjustment.

4. Position the lower stem adjustment button into the upper

stem adjustment holes. The stem length can be adjusted to

fit the person using the detector.

BOUNTY HUNTER CORPORATION • 11900 MONTANA AVE. • EL PASO, TX 79936 • (915) 855-4206

We don’t want you to have any problems with your

detector, but it does happen occasionally. If your detector

fails to operate at all, first check the batteries. If the unit

still does not operate, try clicking the Power Switch on

and off a few times. Sometimes they stick in the off

position.

If you have any questions you may want to call the factory

and ask for assistance.

This unit has a limited 5 Year Warranty to the original

purchaser. If your detector requires service while under

warranty, please return it to Bounty Hunter Corporation

at the address below. It will be serviced and promptly

returned. Units not under warranty will be serviced for a

nominal charge.

TREASURE HUNTER’S CODE OF ETHICS:

1. Respect the rights and property of others.

2. Observe all laws, whether national, state or local.

3. Never destroy historical or archaeological treasures.

4. Leave the land & vegetation as it was. Fill in the holes.

5. All treasure hunters may be judged by the example you

set. Always obtain permission before searching any site.

Be extremely careful with your probing, picking up and

discarding of trash, and ALWAYS COVER YOUR HOLES!

The Search Coil is mounted onto

the lower stem with one thumb-

screw and one bolt included.

The Control Panel is mounted

onto the upper stem with the two

thumbscrews included.

SERVICE

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Bounty Hunter Tracker II Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Bounty Hunter Tracker II