Bounty Hunter Time Ranger Manuel du propriétaire Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 41
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
14
Numeric Target I.D. Readout
This table shows the numbers typically associated with certain
commonly encountered nonferrous metal targets. Older silver US
coins usually read about the same as their modern clad equivalents.
Modern quarter-sized dollar coins like the Susan B. Anthony and the
Sacajawea read about the same as a quarter. Most Canadian coins
which are somewhat similar in appearance to U.S. coinage are minted
from a magnetic alloy which gives very inconsistent readings and may
register as iron. Most one-ounce silver bullion rounds will read in the
same range as the modern U.S. $1 Eagle bullion coin.
foil from gum wrapper 1 - 12
U.S. nickel 5¢ coin 20 - 33
aluminum pulltab 29 - 50
aluminum screwcap 55 - 75
zinc penny (post-1982) 68 - 78
aluminum soda pop can 70 - 105
copper penny, clad dime 90 - 100
quarter 25¢ coin, clad 110 - 122
50¢ coin, modern clad 124 - 132
old silver dollar coin 130 - 140
US silver Eagle $1 coin 130 - 165
Probable Target ID fields
The Probable Target ID fields above the top of the LCD screen
represent the signal ranges produced by various coin and metal object
types. When a metal target is detected, the microprocessor analyzes
the signal and categorizes it based on what kinds of metal objects
usually produce that kind of signal. The microprocessor then lights
up an arrow along the top of the LCD screen which points to the
probable target ID field which corresponds to that signal category.
For instance, if the detected signal fits within the parameters
usually exhibited by zinc pennies and the electrically similar
aluminum screwcaps, the microprocessor may categorize the signal
as "zinc penny - aluminum screwcap". The LCD screen will then
point an arrow to the (Z-1¢ S-CAP) field above the LCD screen.
Above the specific target ID fields, there are two general fields, Gold
Range on the left and Silver Range on the right. Most silver jewelry
is larger and of higher conductivity alloy than most gold jewelry, so
silver jewelry will tend to fall to the right and gold to the left.
Since different metal objects can produce similar signals, and since
minerals in the soil can distort the signals, the probable target ID's
are just that-- probable. There is no way of knowing for sure what's
down there other than to dig the target up and see. Experienced
metal detector users have a rule of thumb-- "when in doubt, dig".
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Commentaires sur ces manuels

Pas de commentaire