Bounty Hunter Time Ranger Manuel du propriétaire télécharger pdf (Page 21)

All Metal Modes

All Metal Pinpoint mode When the ALL METAL-SMART TRAC

button is pushed, the detector switches to the All Metals Pinpoint

Mode. This mode detects all metals and unlike the other modes,

does not require to the searchcoil to remain in motion to detect a

target. However, because this mode tends to drift, you may

frequently have to tap the button again in order to retune (reset) the

signals to zero in order to restore sensitivity. For instructions on

how to pinpoint targets, see page 23.

SmartTrac™ (ground balancing)

Computer-assisted ground balancing increases the usable depth of

the All Metals Pinpoint Mode and the Self-Tuning all metals mode

(Program #4). It does this by cancelling interfering signals from iron

minerals in the ground. This is a feature for the advanced user.

PROCEDURE FOR GROUND BALANCING

1. With the searchcoil more than half a foot above the ground, press

and hold the ALL METAL/SMART TRACK button.

2. Immediately lower the searchcoil to within about half an inch of

the ground.

3. When you hear a wobbly tone (in about 2 seconds), release the

button.

▲ The meaning of the beeps.

1. WARNING BEEP After you’ve been holding the button down for 1

second, there’s a beep to remind you not to hold the button

down unless you are intending to ground balance. When the

computer attempts to ground balance, your existing ground

balance setting (if any) will be lost.

2. WOBBLY TONE After you’ve been holding the button down for 2

seconds, there's a wobbly tone which tells you the computer is

ready to ground balance. When you release the button, the

computer will attempt to ground balance.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 40 41

Pas de commentaire

Bounty Hunter Time Ranger Manuel du propriétaire Page 21